I'd MUCH rather have to finish the mag well area and stockthread
Results 1 to 3 of 3

Thread: I'd MUCH rather have to finish the mag well area and stockthread

  1. #1

    I'd MUCH rather have to finish the mag well area and stockthread

    than try to get the holes located/straight for the firing group!95% AR 15 Lower Receiver, ATF Approved!!! Shipping Now! - AR15.COM

  2.   
  3. #2
    That link is from 2 years ago, and you can buy an anodized "80%" lower that seems to have the same machining done for 30$ less.

    http://www.tacticalmachining.com/80-...-receiver.html

    Sent from my SPH-L720 using Tapatalk 4
    Time to add FireMarshall Bill to the block list.

  4. #3
    The $30 isn't the issue. the issue is it's much harder to line up the holes for the disconncetor and hammer and mag catch than it ws to line up the buffer and the mags. Your's many times more likely to ruin it, after all your work and expense

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Quantcast