Need help identifying part!
Results 1 to 6 of 6

Thread: Need help identifying part!

  1. Need help identifying part!

    Stripped my Taurus 1911 frame to paint it and wanted to see how difficult it would be to reassemble. Only part holding me up is the one pictured here. The only pin that will go through it is the sear pin but I don't know what direction it goes. Anybody know?Need help identifying part!-imageuploadedbytapatalk1370555048.465363.jpg

  2.   
  3. Weaponeer Forums: 1911 schematics

    I don't see it on the diagram.... unless it is 4.17 the hammer pin. You kind of need that. ;-)

  4. Quote Originally Posted by Vencil View Post
    Weaponeer Forums: 1911 schematics

    I don't see it on the diagram.... unless it is 4.17 the hammer pin. You kind of need that. ;-)
    I know it goes in with the sear and disconnect or but the direction it goes is what's getting me.

  5. The short leg goes backward horizontally. The long leg rests on the trigger bow.

    It's part number 104 in this diagram, just to the right of the sear.

    http://www.brownells.com/userdocs/sc...deltaelite.gif

    Here's how it sits in the gun.

    http://www.m1911.org/images/safety.jpg


    Edit: Here's video that shows it fairly well.

  6. #5
    It's called the trigger lever bar. It slides in between the sear and the frame, on the far right side as you look into the frame from the rear of the gun. The point , or "duck head" as some call it, pointing toward you.

  7. Thanks guys I finally got it. Thanks for all the help.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Quantcast