5.56 ammo ONLY
Page 1 of 2 12 LastLast
Results 1 to 10 of 13

Thread: 5.56 ammo ONLY

  1. #1
    Join Date
    Aug 2011
    Henrico, Virginia

    5.56 ammo ONLY

    is there a site that sells basically only 5.56 ammo and not .223/5.56.

    Im quite peculiar about my round but most sites when choosing a caliber have links for .223/5.56 and not just 5.56

  3. #2
    Can you explain why?..... I always wondered the ballistic differences ....

  4. #3
    Join Date
    Jun 2011
    Off of I-80 between Des Moines and Cheyenne
    Blog Entries
    Quote Originally Posted by fourmula766 View Post
    Can you explain why?..... I always wondered the ballistic differences ....
    I've wondered that also, and think that case dimensions are slightly different maybe is all? I dunno, some say (and I've never read anything to the contrary) that the 5.56 is 'normally' loaded for a higher pressure. This discussion might be a jumping off point for looking into it perhaps: 5.56 VS .223 Ammunition and Chamber Dimensions - AR15 Armory.com

    Here's another one if ya like: The Gun Zone -- SAAMI on 5.56 v. .223 Remington

    There are places o' plenty to get 5.56, here's one: http://www.natchezss.com/product.cfm...AC&src=tpSlrHm
    1)"When injustice becomes law, resistance becomes duty." -Thomas Jefferson.
    2)"Imagine how gun control might be stomped if GOA or SAF had the (compromising) NRA's 4 million members!" -Me. http://jpfo.org/filegen-n-z/nraletter.htm

  5. #4
    Quote Originally Posted by biscotrip:245386
    is there a site that sells basically only 5.56 ammo and not .223/5.56.

    Im quite peculiar about my round but most sites when choosing a caliber have links for .223/5.56 and not just 5.56
    There in no such thing as .223/5.56 ammo. It is either one or the other. If your gun is chambered for 5.56 you can use either, if it is chambered for .223 you can only shoot .223.

  6. There seems to be way too much confusion about 5.56x45/.223 Remington ammo. Simply put, one is a military designation while the other is civilian(conforms to SAAMI specs). I challenge the OP to tell the difference between the two types if mixed in a single magazine(in a 5.56 chamber).

  7. 556 only

    Brownells now has an Ammo Division...

  8. #7
    Why? Is the barrel made differently for the 5.56 to take a hotter load?

  9. #8
    Quote Originally Posted by Lepine1 View Post
    Why? Is the barrel made differently for the 5.56 to take a hotter load?
    It is a different caliber, the differences make it dangerous. This is one if the most discussed gun questions on the internet, google it and read up from a source you trust.

    Sent from my PG86100 using Tapatalk
    Time to add FireMarshall Bill to the block list.

  10. #9
    .223 Remington vs 5.56 NATO

    Plus I found this so I'll pass it on.

    Q. What is the difference between 5.5645mm and .223 Remington ammo?

    In the 1950's, the US military adopted the metric system of measurement and uses metric measurements to describe ammo. However, the US commercial ammo market typically used the English "caliber" measurements when describing ammo. "Caliber" is a shorthand way of saying "hundredths (or thousandths) of an inch." For example, a fifty caliber projectile is approximately fifty one-hundredths (.50) of an inch and a 357 caliber projectile is approximately three-hundred and fifty-seven thousandths (.357) of an inch. Dimensionally, 5.56 and .223 ammo are identical, though military 5.56 ammo is typically loaded to higher pressures and velocities than commercial ammo and may, in guns with extremely tight "match" .223 chambers, be unsafe to fire.
    The chambers for .223 and 5.56 weapons are not the same either. Though the AR15 design provides an extremely strong action, high pressure signs on the brass and primers, extraction failures and cycling problems may be seen when firing hot 5.56 ammo in .223-chambered rifles. Military M16s and AR15s from Colt, Bushmaster, FN, DPMS, and some others, have the M16-spec chamber and should have no trouble firing hot 5.56 ammunition.
    Military M16s have slightly more headspace and have a longer throat area, compared to the SAAMI .223 chamber spec, which was originally designed for bolt-action rifles. Commercial SAAMI-specification .223 chambers have a much shorter throat or leade and less freebore than the military chamber. Shooting 5.56 Mil-Spec ammo in a SAAMI-specification chamber can increase pressure dramatically, up to an additional 15,000 psi or more.
    The military chamber is often referred to as a "5.56 NATO" chamber, as that is what is usually stamped on military barrels. Some commercial AR manufacturers use the tighter ".223" (i.e., SAAMI-spec and often labeled ".223" or ".223 Remington") chamber, which provides for increased accuracy but, in self-loading rifles, less cycling reliability, especially with hot-loaded military ammo. A few AR manufacturers use an in-between chamber spec, such as the Wylde chamber. Many mis-mark their barrels too, which further complicates things. You can generally tell what sort of chamber you are dealing with by the markings, if any, on the barrel, but always check with the manufacturer to be sure.
    Typical Colt Mil-Spec-type markings: C MP 5.56 NATO 1/7
    Typical Bushmaster markings: B MP 5.56 NATO 1/9 HBAR
    DPMS marks their barrels ".223", though they actually have 5.56 chambers.
    Olympic Arms marks their barrels with "556", with some additionally marked "SS" or "SUM." This marking is used on all barrels, even older barrels that used .223 chambers and current target models that also use .223 chambers. Non-target barrels made since 2001 should have 5.56 chambers.
    Armalite typically doesn't mark their barrels. A2 and A4 models had .223 chambers until mid-2001, and have used 5.56 chambers since. The (t) models use .223 match chambers.
    Rock River Arms uses the Wylde chamber specs on most rifles, and does not mark their barrels.
    Most other AR manufacturers' barrels are unmarked, and chamber dimensions are unknown.
    Opinion: In general it is a bad idea to attempt to fire 5.56 rounds (e.g., M193, M855) in .223 chambers, particularly with older rifles

  11. #10
    Join Date
    Nov 2011
    Northern Wisconsin
    Very good explanation stan45, you saved me a lot of typing! I get this question several times a month. Happy shooting!
    Endeavor to Persevere, Freedom is not Free

Page 1 of 2 12 LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts